How to Read and Clear Fault Codes. When a problem arises in your Ford vehicle, the corresponding control module promptly identifies the issue and generates a Diagnostic Trouble Code (DTC) that corresponds to the specific fault. These fault codes [1], accompanied by warning lights on the dashboard, such as the Check Engine Light, ABS [2] Light
What is the Cost to Diagnose the Code P0135 Ford? Labor: 1.0. The cost to diagnose the P0135 Ford code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour. 1. Loose ABS Speed Sensor Wiring. Loose or damaged wiring is a very common reason for problems with the ABS system. Minor damage to the speed sensor can cause the ABS system to activate when it doesn’t need to and this can cause the ABS warning light to flash on but not register as a fault with the ECU. In this video we shall be diagnosing and fixing a 2019 MK4 Ford Focus. The vehicle has an ABS warning lamp on with a C003A fault code stored for a right rea The next step is to see if the engine temperature sensor is working correctly. If you have a scan tool with live data, check the engine temperature when the engine is cold, it should be close to outside temperature. Drive a car for 10 minutes and check the engine temperature again, it should be close to 180-220°F or 82-105°C. See the photo. The P1450 code indicates that there’s too much vacuum in the EVAP system or fuel tank. This situation means the PCM cannot bleed the vacuum to maintain proper pressure. If the high vacuum remains for longer than sixty seconds, the PCM detects a fault. The Check Engine Light comes on, and the P1450 code gets set in the system. D5g1zv.